Span Array - Data located contiguously on one disk then on another disk, and so on.RAID-5 Array - Data located in stripes distributed between two or more drives with parity control.Mirror Array (RAID-1) - Data on two disks is identical - provides complete data duplication (or mirroring).Stripe Array (RAID-0) - Data located in stripes (blocks of size 32KB, 64KB, 128KB, etc.) distributed between two or more drives.To choose a supported RAID type, in the Virtual Volume Type area, choose one of the following:.To open Recreate Disk Array (RAID) dialog, in the Action menu, choose Recreate RAID (Virtually).If you don't see your data or if there was an error during virtual array creation, mark this one as a failure and try another order of disks in array. If there are four disks, 24 combinations, and so on.Įach time you try a combination, write down the order you are trying, click OK and check the results by trying to access and scan the newly-created virtual RAID that is added to the list of Local System Devices. If there are three disks, you must try a maximum of six combinations. You have only two ways to arrange the order. If you are dealing with only two disks, it is simple. The only way to discover the correct order is to try all available combinations until you reach the one that works. In most cases, the correct order is unknown. It is also important to list the disks in the correct order when making a virtual disk array.
It is important that you specify the parameters of the RAID system that you know existed before the fault so that you can virtually reassemble the same system. You can even to create a Disk Image for the whole RAID and store it to the safe location. With this virtual configuration, you are able to perform all drive file recovery manipulations as though it is regular drive. You can combine together a disk that was previously used as a part of a RAID system in a temporal (virtual) disk array.
UNERASER provides an easy way to assemble array disks together and make damaged or deleted data accessible.
CREATE BOOT PARTITION IN RAID SOFTWARE
There are many reasons for a Redundant Array of Independent Disks (RAID) system to fail (RAID controller failures, software RAID emulator errors, etc.). Re-create Deleted or Damaged Disk Array (RAID) Virtually
0 kommentar(er)
